This is a fully proportional speed control (both forward & reverse) with exceptional low speed performance.  The unit is rated from 6 to 16 volts and a true continuous current rating of 25 amps with a 35 amp surge.  This unit is a non-BEC unit so the receiver must be powered from receiver batteries or a separate BEC unit.  Fuse protected at 25 amps. 

The unit has built-in Fault Protection Circuits with indicators (Green for power, Red for faults), for Over Voltage, Over Current, and Over Heating, and are fully automatic with auto reset.  The unit is forced air cooled with it's own built-in blower.

Two speed controls can be operated from one channel on the transmitter with an additional jumper connector (# 7300-1--$4.50) to connect the two speed controls together.

The unit is supplied with a connector combo plug for use with older receivers which use male servo lead plugs, a Tamiya battery input plug, and bullet motor connectors.  Comes with Velcro^® for mounting.

This is a fully proportional unit both forward & reverse, with an automatic temperature  shut-off. It can handle up to 8.4 volts with the BEC on, and up to 14.4 volts with the BEC off.  It uses 6 to 12 cells and will run modified motors down to 12 turns.  It has the added feature of being able to be set up for one-way speed control for racing, or two-way speed control (forward & reverse) for sport or scale boats.

Operates at 6 to 8.4 volts with BEC unit and from 8.4 to 14.4 volts with BEC turned off .  Features thermal shut-down due to overload and restart when cooled off. 

#7068 - for use with Twin Motors
      6 to 8.4 volts - 12 turn minimum
               motors with BEC.
      8.4 to 14.4 volts - without BEC (12 volt
               motors ONLY)   

7068   $70.00

Note: #7067 has been discontinued by the manufacturer.

Length:  2.17"           Height: 0.85"
   Width:  1.75"            Weight:  3.5 oz.

The unique set-up of this unit allows for two 7.2 Ni-Cad packs to plug directly to the speed control without a "Y" harness.  It can be used for single or twin motor set-ups with no additional wiring.  Rated for 14.4 volts at 30 amps continuous, it also has a built-in BEC with an on-off switch for the receiver.  This unit can run two 19-turn minimum motors, fully proportional forward and reverse, and also features a built-in thermal shutdown.

This is a high voltage, high current speed control with proportional forward only.  The unit has no BEC circuit so the receiver battery pack must be used.  Rated to handle 60 volts at 50 amp current draw.  It comes with Astro Flight connectors installed.

Price:  $95.00

This fully proportional electronic speed control (forward & reverse) is rated at 30 amps continuously.  It handles 6 to 14.4 volts and has a built-in BEC circuit.  This is the perfect unit for high powered single or twin engine installations and comes with Astro connectors.